r/edmproduction • u/fatberrydsp • 8h ago
Keeping a reese bass wide on top but solid in mono underneath (stock tools, any DAW)
A reese sounds huge on its own and then smears the whole low end once the kick and drums come in. This is the split I use, all with stock plug-ins.
Duplicate the bass channel (or use your DAW's crossover/multiband split if it has one). Low-pass the first copy at about 120 Hz and high-pass the second copy at the same point.
Make the low copy mono with your utility or stereo tool (width 0). If it vanishes on phone speakers, add a touch of saturation to this copy only.
Keep all the detune and chorus width on the high copy. If it gets boxy, a gentle EQ dip somewhere around 300 to 500 Hz usually cleans it up.
Sidechain only the low copy to the kick, so the movement up top stays intact while the sub ducks out of the way.
Flip the master to mono and listen. If the top half nearly disappears, the voices are too out of phase, so pull back the detune spread or chorus mix until it still reads in mono.
What crossover point do you all use for this? I find 100 to 150 Hz works for most reeses, but it depends a lot on the key.