Hey everyone
I have a 1982 Datsun 280ZX with factory EFI. I've been dealing with some fuel related issues, but recently a new problem popped up.
Existing issue (mostly when cold)
For a while the engine has been running rich, with a noticeable smell of raw gasoline from the exhaust. When starting the engine cold, it runs pretty rough, misfires, and shakes. However, once it warms up it usually runs smoothly and the rough running goes away but still runs rich.
The new issue is I've noticed that even when the engine is fully warmed up (temperature gauge sitting around the middle, after driving for half an hour or more), it starts misfiring and shaking between approximately 1,200 and 1,500 RPM.
It almost sounds and feels like a 2-step rev limiter😂 Once I get past that RPM range, the engine runs smooth.
I've also noticed something strange with the fuel tank, when the fuel level is very low, like almost empty, the engine starts surprisingly easily and pretty fast that even I can't hear the starters sound, even after sitting for several days. However, after adding around 10.3 gallons of fuel, cold starts become noticeably harder and require few seconds of cranking.
Also, when opening the gas cap I can hear a noticeable hiss of escaping pressure and smell gas. Also this is an old problem.
I've checked
1-Ignition timing is set to approximately 8–10 degrees BTDC.
2-Spark plugs and spark plug wires are new.
3-Ignition coil produces a strong blue spark.
4-Checked fuel pressure after the fuel filter and is around 30 PSI at idle and rises to approximately 40 PSI when revving or removing the fuel regulator vacuum hose.
5-Coolant temperature sensors have been checked and seem to be working properly.
6-The coolant temperature sensor on the thermostat housing was recently replaced.
Has anyone experienced similar issues with an L28E?
I'm particularly interested in what could cause the new misfire at 1,200–1,500 RPM even when the engine is fully warmed up
Any advice on what to test? Thanks alot