TL;DR: My Lenovo Tab P11 Pro Gen 2 (TB132FU / MT6893) froze while charging and is now stuck in a black screen / MediaTek BROM mode loop (COM5/COM7). Lenovo Software Fix hangs at 38%, `mtkclient` fails due to DAA/SBC security, and SP Flash Tool fails at the DA2/DRAM stage (`STATUS_BROM_CMD_JUMP_DA_FAIL`). Looking for a way to kick it out of BROM mode or get the flash tool to pass the handshake.
What happened: The tablet was plugged into the charger, and the "Smart Charging" notification froze on screen. I forced a reboot using Power + Volume buttons, and the screen has been completely dead since (no backlight, no logo, no charging icon). When connected to a PC, Device Manager only sees it as a MediaTek USB Port (COM5/COM7). Holding the power button for 20–30 seconds caused a single vibration once, but the display stays black.
What I have already tried (with AI troubleshooting help):
* Hardware resets: Tried every button combination (Power alone for 30s, Power + Vol Up, Power + Vol Down).
* Lenovo Software Fix (RSA): Downloads the stock ROM (`TB132FU_S340159_250710_ROW`) properly, but always hangs indefinitely at 38% ("Connect device and do flashing").
* mtkclient: Detects the MT6893 chip, completes the handshake, and disables the watchdog, but Kamakiri fails because DAA and SBC security are enabled. Passing the official `.auth` and signed DA files extracted from the RSA folder also fails at the payload stage.
* SP Flash Tool (v5): Loaded the official scatter, `auth_sv5_onyx.auth`, and `MTK_AllInOne_DA_onyx_signed.bin` from the RSA directory (also tried unchecking `preloader` and switching between Download Only and Firmware Upgrade*). The red bar (**Download DA 100%*) finishes fast, but jumping to DA2 / initializing DRAM either throws `STATUS_BROM_CMD_JUMP_DA_FAIL (0xC0060004)` or hangs at 100% red bar for 4 minutes before throwing `STATUS_DEVICE_CTRL_EXCEPTION (0xC0050001)`. (UsbDk was already uninstalled and PC rebooted to rule out driver conflicts).
Questions:
- Is there a specific SP Flash Tool v6 build (or V6 DA protocol tool) needed to properly initialize DRAM on the MT6893 / Kompanio 1300T?
- Any trick to force Lenovo RSA past the 38% handshake hang, or a way to reset the PMIC/display latch without opening the tablet?
Any help would be appreciated!