r/BitcoinMining • • 1h ago

General Discussion I Overvolted the APW3 on my Bitcoin Loki miner (12V → 12.5V → 14.1V). Here’s the data

Thumbnail
youtu.be
2 Upvotes

Been running a Loki setup (single S19k hashboard + modded APW3++) for solo mining and
wanted to see how much headroom was left in the PSU. So I modded the APW3 to run
at higher voltages while keeping the same frequency
Voltage
Hashrate
Efficiency

- 12.0V (stock)
23.7 TH/s
[24 J/TH]
- 12.5V
[27 TH/s]
[20.5 J/TH]
- 14.1V
29.35 TH/s
[27.3 J/TH]
Why is it that when the Voltage bumped to 14 it had worse efficiency. I would assume the closer it got to the APW12 stock Voltage the better?
If anyone wants to follow along or see the modifications I did, I recorded the
experiment/guide here:
Video: https://youtu.be/qLMW4oa33nM
Safety note: this runs the PSU outside its stock spec. Watch your PSU temps,
use a properly rated circuit, and don't leave it unattended until you've verified
it's stable.
Question for others using Loki miners: what voltage are you running, and are you
optimizing for TH/s or J/TH? Curious whether anyone's hit a sweet spot of Volt/Freq on the S19’s to get the best balance?