r/BudgetAudiophile • • 1h ago

Tech Support How do I connect Edifier MR3 to Active subs?

Post image

Sorry if it’s a common question, I’m new to this, I’m not familiar with audiophile equipments at all.

1 Upvotes

6 comments sorted by

4

u/VinylHighway 1h ago edited 27m ago

You will either need to split the source into the subwoofer and the speakers and control the volume from the source otherwise you’ll need to adjust the subwoofer volume independently of the speaker volume. Or get a pre amp with more than one output or a subwoofer out. Or get a subwoofer with speaker level inputs but since only one speaker is passive you’ll lose half the bass data. Or get an AVR with pre outs to use as a pre amp.

You could also buy a MiniDSP to create a sub out

1

u/bgravato 1h ago

You don't, those speakers do not have an output for a sub...

You may do the other way around, depending on what sub you have... can you post a photo of the sub connections instead?

1

u/killingjoke619 9m ago

I don’t have a sub yet I’m thinking on getting the Edifier T5

1

u/bgravato 3m ago

With that one, you can connect the RCAs coming from the source (I'm guessing a PC) to the Signal In on the sub and then from Signal Out into the speakers.

1

u/VinylHighway 27m ago

I'd say a pre-amp with more than one output would be their best bet. My Schiit has RCA and XLR outputs and you can leverage the unused one with adapters to a subwoofer.

1

u/Many-Researcher-8125 1h ago

I am using t5s with d12 with split source. Sub to speaker sounded bad and speaker to sub had very low bass.