Hi all, not sure if this is the right community to be posting this in, this is far from my area of expertise. I’m trying to get some acrylic templates cut out, photos 2 and 3, just simple shapes as pictured. When I sent the SVG files to the company, they appear as rectangles as shown in photo 1. I used Canva to make the shapes and exported them as SVG files, I am not sure which program they are using. Does anyone know what might be causing this? When I open them they show up properly
I am not a machinist. I am not making pieces for sale.. I am making parts for our machines in-house.
Anyway, I am looking for a used machine to build pieces that look kind of like this:
But imagine them being a foot across and almost 5 feet long (300mm x 1400mm). The holes in the top are radial, and there will be a LOT of them. These will be made out of alumimum.
The plan will be to do the bottom surface first because the bottom surface has mounting points, and a fixture will be built that the piece can be fastened to with fasteners from the bottom so that the top and sides can be profiled in one long session.
I don't care how fast it is. I will be setting it up and starting it then letting it run all night, so it will have 16 hours to do each piece. I can run it gently to LESSEN the risk of traumatic failure.
I have seen HAAS VF6's on the market, and they seem like a good prospect. 64" of travel should be sufficient, I think.
I know I need a chip conveyor.
Is there anything terribly important that I'm not thinking of (other than the obvious you-shouldn't-be-doing-this-you-don't-know-what-you're-doing part)?
I’m looking at a 2016 Tormach SL15 pro tomorrow. Anything I should be looking at specifically with this model? Did these lathes change much over the years? They’re asking $10k USD