r/CarAV • • 8h ago

Recommendations What's your favorite ridiculous 90s/00s motorized headunit in the mid-range?

Post image
35 Upvotes

Just imported a super silly turbo kei van and i'm looking to indulge all those childhood fantasies. i'll expand the original functionality with BT which is all i use so built-in needs only decent output specs and an ultra sweet display


r/CarAV • • 7h ago

Tech Support Need some professional help with my Shelby Daytona.

Thumbnail
gallery
18 Upvotes

I have an 86 Daytona CS Turbo Z with an all JL stereo set up and I cant quite get it to where I am happy with it. The set up is minimal to save weight but still provide decent sound which is pretty normal for every stereo I put in my cars and I have had good results until now.

The gear is

Pioneer SXT-C10PS retro head unit running the Pioneer Smart Sync app

JL Audio RD900/5 amp

JL C3 600 components up front in the door

JL C3 570 components in the rear sail panels

JL cf350 m/t in the dash

JL 10Tw3 10" shallow sub in sealed .5cu ft. box as recommended.

Its been time aligned using the dash and doors, then I tried doing just the doors and rears, now Im about to take it all out and try something else. It just gets muddled and harsh at higher volumes that a $575 component set should have no problems handling. Its wired with the components running off the amp, the dash is off deck power and of course the sub is off the sub channel.

How would you wire this set up for maximum effectiveness?


r/CarAV • • 22h ago

Recommendations 8 channel dsp recommendations?

10 Upvotes

I have an SQ setup and need 6 channels for front stage and 1 for sub. Morel 3 way components.

Helix is a little out of my budget, and the audio shop said the software is too advanced for them to tune.

Was looking at Dayton audio dsp it’s 200, i don’t wanna cheap out but can’t find anything in between those 2 price points


r/CarAV • • 23h ago

Recommendations 2016 tacoma 2.7l alternator (pic for attention)

Post image
9 Upvotes

Just bought a 2016 toyota tacoma 2.7l, after recently crashing my suv im looking for a high output alternator 320+amps for it. Ive worked with mechman and js in the past but i do not believe either of those brands make one for my vehicle.


r/CarAV • • 5h ago

Recommendations Battery sensor advice

Thumbnail
gallery
6 Upvotes

Battery sensor is on the negative terminal. Frame to battery is welded to the copper input bus for the sensor. What do you think for adding big 3 frame to batt? Is there a preferred way to do this? I had 2 ideas.

The first and easiest would be to drill a hole in the circled area in the 2nd Pic and bolt to it. It appears to be the same size as the bus on the sensor, so should be able to carry the current.

The second and more annoying method would be to gently (with a grinder) separate the connection, then drill a hole in the copper to bolt through.

I feel like either would work fine. Just curious what the pros do. Maybe there's a super cool secret method that's even better.


r/CarAV • • 22h ago

Tech Support Voltage fluctuations

8 Upvotes

Have a new 250 amp alternator from powerbastards. I also have a big 3 upgrade down with 0/1 gauge ofc wire. All wires are securely attached and to bare metal. I got a new battery October 16th and had my charging system tested at o rielys and they said it passed the test. About 2 weeks ago I threw a sub in with spare parts I had laying around only running 200 rms and today I was experiencing fluctuating voltage jumping up to around 19v and dropping back down immediately to 12v. The battery light would also show this fluctuations. Any ideas about what it could be would be helpful I dont know what to do next.


r/CarAV • • 14h ago

Recommendations Pros and cons of these retro-style headunits? (Kenwood DPX395MBT shown)

Post image
5 Upvotes

Anyone have any insight on these units? As far as I know this came out in 2020


r/CarAV • • 6h ago

Recommendations System for a 1968 Cadillac

Post image
5 Upvotes

Building an entire sound system for my 1968 Cadillac Coupe De Ville and wanting to see if I’m on the right path!

After lots of reading and research (lots of it on this sub) I think I’ve finally put together a complete system for my car and want to see what you guys think/ if I need to change anything before I buy.

Head Unit
Kenwood Excelon KMM-X705
Needs to be a single din as I want to hide it in the glove box

Front speakers (component)

Alpine R2 R series Pro 6 1/2 2 way
100 watt RMS
(Is the 200$ upgrade to the 3 way worth it)

Rear speakers (Coaxial)

JL Audio C2-690tx
70 watt RMS
(Not super set on these willing to swap them out for a better recommendation. Definitely Wanting more bass/better sound though then something that’s just louder)

All the speakers will be driven by an

AudioControl EPICBIGFOUR AMP
200 watts rms x4

Rear sub (already purchased I got a smoking deal so couldn’t pass it up. Yes there’s probably better but not for 350$ total for sub, amp, and box)

SKAR EVL 15 inch subwoofer 2500 rms in custom built box tuned to 35 hertz and matching SKAR amp

Car has a dual battery setup wired in parallel and will have a 320 amp alternator. 1/0 AWG OFC wire will be ran to the amps as well as Big 3 upgrade. 12 AWG wire will be ran to all the speakers. Doors will have custom speaker holes made in them and will have the correct sound dampening installed in the door and the whole car.

Anything I’m missing or think I should change please let me know! Want this car to bump! Thanks in advance everyone and here’s the car in question


r/CarAV • • 6h ago

Recommendations Am I missing anything?

Thumbnail
gallery
4 Upvotes

In my 40s now and haven’t done anything car audio related since my teens, so I’m looking for help making sure I’m not missing anything. Looking to put this setup in my ‘26 Pilot just for some extra low end, nothing crazy.


r/CarAV • • 10h ago

Tech Support Amplifier tuning

3 Upvotes

When setting the gain on an amplifer for subs what should the head unit settings be, for the eq, sub speaker level, and bass boost, The way I did it was I maxed my sub speaker level and set my eq to how I like it and no bass boost then I set my gain with my multimeter. Also what do you put your other amp setting to while setting gain? should you put them to min or to what they should be according to your sub specifications. Thanks in advance I apricate any advice.


r/CarAV • • 3h ago

Recommendations EBAY Mid and Tweeter Pods

2 Upvotes

Is anyone currently using or have used mid and tweet pods like this?

https://ebay.io/m/5iBtiI

I’m looking for some pods, and I can’t find any custom ones for my car and year. These seem simple, is there any downsides to these compared to anything else?


r/CarAV • • 5h ago

General Upgraded the door speakers.

Thumbnail gallery
2 Upvotes

Im thinking I might have a professional install the amp and deck speakers lol.


r/CarAV • • 7h ago

Recommendations My First Porsche. A 2018 S with 38K miles. I am changing the entire Bose system.

Post image
2 Upvotes

r/CarAV • • 9h ago

Recommendations Blown out car speaker

2 Upvotes

Best places in LA to get car subwoofer replaced??


r/CarAV • • 11h ago

Tech Support Noob - Battery terminal connection recommendations

Post image
2 Upvotes

Guys, new at this. Trying to wire in a powered sub (Kicker Hideaway) and I’m 90% there. Want some advice because feeling unsure about this. Does this look sufficient for a ring terminal connection or should I move it to the bolt side? Would adding washers be good practice or unnecessary? Probably already know the answer here but do I need to scrub the terminals?

Thanks in advance!


r/CarAV • • 15h ago

Tech Support Bass sounds late - help please

2 Upvotes

I recently purchased a new Chevy Silverado with Bose factory stereo and the bass was terrible coming from my previous stock radio with alpine system and sub. I used to compete in car audio 20+ years ago and don’t recall ever having this issue, but here’s what’s happening

The bass feels late/ delayed. When playing a song with a fairly tight, punchy bass, it becomes much more noticeable.

Here’s my setup

Stock Bose radio
Audio control lci2 pro tied into front right factory speaker wire
Audio control epic 1000 amp
2 kicker L7 10” shallow subs (dual 4, wired to 1 ohm) in a .9 cu ft sealed box under the rear bench seat, firing down

Any suggestions to adjust the timing of the bass?


r/CarAV • • 23h ago

Tech Support Tweeter Noise

2 Upvotes

What can be causing this noise and sometimes when I’m playing music it makes a crackling noise.
Amp is an Alpine PDX 4.100 tuned to rms for both the speakers and tweeters and I’m running the Hertz CK 130 2-way components Active, I have an Alpine Pxe C60 DSP running the crossovers. Can it be that the amp is becoming faulty?


r/CarAV • • 1h ago

Recommendations Comparing two 10in sub options for DS18 JBASS

Post image
• Upvotes

Which one is better for this box? I am down for other recommendations too. I want loud and hard hitting. I have to stick to this box though, I cant take up too much cargo space in my Jeep.


r/CarAV • • 3h ago

General Monoblock Amp Help Please

1 Upvotes

Newbie here. If I have two 2 ohm dvc 12 inch subs, do I need to wire the mono block amp to two ohms? And how big of an amp should I get? I’m confused. Thank you for the help.

It will be running two NVX NSW122v3 subs. 500 W RMS. 1000 W max.


r/CarAV • • 3h ago

Recommendations I need help

1 Upvotes

So I have a 2019 honda hrv I really like my stock door speakers and head unit im just trying to figure out what I need and what I want for a sub I have a decent budget could probably spend 5 or 600 on it but I dont want something massive maybe a under seat box with 8s or 10s. I just need advice on all of it I dont know if yoy cant even really Modified the alternator or anything like that on my car. Just help me please!


r/CarAV • • 4h ago

Tech Support Bass gone in harmon kardons

1 Upvotes

I own a 2019 330i with a harmon kardon set.
Everything sounds fine except for bass, there are no vibrations and it sounds completely flat.
My brother who owned the car when the bass went out said it was an amplifier issue caused by heat from summer paired with the black interior.

Me and him know little about sound systems so we checked fuses and wiring (all fine)

Is his conclusion correct? And if so which part should I purchase?
Thanks.


r/CarAV • • 5h ago

Tech Support Power limitations?

1 Upvotes

I know rms is were you wish to add as it is the what the speaker can handle but my question is if i have a 3.5" midrange rated 50w rms -100w max at 4ohm with 200-18000hz range i am running a fully active system and have them crossed over at 300hz - 5000hz at the moment but my amps rms is 75w x 4 at 4ohm would it be safe to run at the 75w or do i have to limit the power to 50w if so how would i go about doing that?

any information is helpful


r/CarAV • • 7h ago

Discussion Taramps good value?

1 Upvotes

Is taramps a good value brand? Seems like theyre price is pretty good and i feel like i see them a decent amount on setups plus they make some high wattage stuff


r/CarAV • • 7h ago

General Need help and advice

1 Upvotes

Alpine R2-S65C 6.5

Alpine R2-S65 6.5

Kenwood DDX9703S

2 Gauge welding cable power/grounds.

2015 mazda 6, 14 gauge speaker wire, relatively short runs.

Wired directly from radio harness connector to amp, utilizing factory wiring from there into the doors.

I have spent a huge amount of days trying to fix this myself and checking things, ill summarize a timeline:

Ran all four speakers on a Pioneer GM-E360X4 for about a year, never an issue

Wanted to bridge, bought a second Pioneer GM-E360X4, was good until the R2 coaxials went into protect, spent alot of time checking so much, including in the doors. Got to the point where I returned the amp for a different brand new one. Quickly the same issue occurred.

Did some little tests, protection occurs when they are bridged, protection does NOT occur when they aren't bridged. Never once had the original amp go into protect, so I wired them up so that one coaxial and one component were bridged together separately, both amps went into protect.

Protection doesnt occur immediately when turned on, seemly a shortish random time after I started listening and most likely louder volume. There is a certain song I like and I swear it would go into protect at a specific part of that, its not some heavy bass song it was a halsey song.

This is all awhile back, but I had also tried swapping power, ground, rcas, and fuses, with the same protect resulting. I set my amps with a multimeter to the rated rims, raised the amps for better air flow and added fans. To my best ability im pretty sure I tried checking ohms for those speakers and impedance in the speaker wiring and things seemed fine but I don't even know at this point.

I've redone wiring and connections so many times over the last year that I just don't even know what to check at this point.

I ended up just running the rear speakers unbridged for quite awhile and everything's been fine, yesterday i bought a Pioneer GM-DX874, wired up all 4 speakers and sounds incredible, but randomly cutting out at seemingly random cutting out, cuts out in a song, I rewind to see if it happens again at the same point, then its cutting out at part before that part, cuts out few seconds cuts out few seconds ect

I haven't been able to investigate this new amp yet or if its going into protect or not, but I just think its something to do with those coaxials.

Sorry for the long post, im truly at my wits end with the mindset that no matter what I check or try that it is not going to work. Thank you in advance for any advice or knowledge


r/CarAV • • 7h ago

Tech Support Hail Mary request for Kenwood te2163k.krm - Firmware

1 Upvotes

I desperately need this firmware, but Kenwood’s website has been broken for awhile due to the PHP vulnerability. 
I've emailed their support 3 times now, with no reponse yet.
If anybody has downloaded it before the website went down, could you possibly share it?

te2163k.krm

Thanks,