r/Chevy • u/badboss2008alt • 9h ago
Discussion Whats up with it
My Coworker Recently picked up a 09 hhr, I looked in the under hood fuse box and saw this anyone know what's up
The radio also comes up as locked and the abs says Vin not programmed but it runs and drives good
r/Chevy • u/Minimum_Flatworm_767 • 10h ago
Repair Help 2016 Malibu Hybrid – loses propulsion while driving, then drops out of READY on restart (P16E0)
I have a 2016 Malibu Hybrid with the 1.8L and about 122k miles, and I’m dealing with an intermittent problem. It doesn’t happen every day, but every time it has happened has been in the evening when it was cooler out, which may or may not mean anything. It starts while I’m driving. The car suddenly loses propulsion, the power steering goes out, the check engine light comes on, and I get “Shift to Park” on the screen. After it stalls, I restart it and READY comes on, but about 10 seconds later READY drops out, the power gauge falls to OFF, the “Drive Cycle Summary” screen pops up, and shifting into Drive or Reverse just gives me “Action Required – Shift to Park.” The car won’t move. The first time, I was able to get home by stopping and restarting several times.
O’Reillys pulled P16E0 (Engine Performance – No Torque Detected). I replaced the 12V battery first, but that didn’t change anything. When the car was stuck in this state, unplugging the MAP sensor got it driving normally again. After I plugged it back in, the problem didn’t come back right away, so I’m not sure if the sensor is the cause or if unplugging it just reset things. I’ve ordered a new MAP sensor anyway, and while I’m at it I’m replacing the air filter, cleaning the MAF, and putting dielectric grease on the MAP plug.
Has anyone had a bad MAP sensor cause P16E0 or a shutdown like this on the Malibu Hybrid? I’d also like to know about any wiring or connector problems around the MAP sensor on the 1.8L, or anything else I should check if the new sensor doesn’t fix it. TIA
r/Chevy • u/SadPin8982 • 15h ago
Sedan Saturday Doesn't get much better
Trailblazer SS Toy Hauler
r/Chevy • u/Few_Relationship_235 • 22h ago
Picture Managed to get myself an 06 suburban 1500 ltz with the 6.0 lq4
Absolutely beautiful truck that rumbles and pulls; just waiting to save up to get some of the frame rust treated and probably get a new exhaust.
r/Chevy • u/nigelthrowaways • 1d ago
Discussion 2023 Blazer tire size from dealer
I received a winter tire package from my dealer after purchasing the vehicle. The OEM tires are 235/65/18, however the winter tires are 255/65/18. The tires rub against the wheel well, but the dealer states we sometimes use tires of slight variance and it makes little difference overall.
Are there any owners out there running on 255s? Having to argue with a dealer over something so obvious is draining.
I contacted GM Canada and they stated that since the tires were purchased from the dealer they are seen as an accessory and that the dealer is able to make suggestions and substitutions not conforming with GM itself. Also GM wouldn't do anything to help, only to say, take it up with the dealer.
r/Chevy • u/Proper_Switch9034 • 1d ago
Discussion Chevy Equinox - Capless Gas Cap - Flapper Repair/Replacement
The Metal Flapper with the rubber seal disconnected from the spring that holds it flat against the housing, has anyone out there experienced a similar issue? I can see the small "bar" where the hinge at the top of the neck/housing connects to the flapper door and I can get the piece back into its original position with the spring holding it closed, but i cannot get it to clamp to the hinge bar at the top so its basically just pressed up against the housing. Does anyone know if the entire assembly has to be replaced or if its possible to just replace the capless gas cap at the top of the filler neck.
2019 Chevy Equinox - AWD
r/Chevy • u/Wayniac666 • 1d ago
Discussion 2011 Silverado 1500 Infotainment system: No Android, but Apple Works?
I have a 2011 Silverado 1500 (5.3l) truck with the factory single CD style head unit in it, dont kniw the model number. It has a USB port in the center of the dash and when I connect an Android, the Android is not recognized and the head unit says "Could Not Connect, USN Connection Not Supported".
When we plug in my girlfriend's Apple phone, the head unit recognizes it and she's able to play music. I'm curious if there is any way to make my Android recognizable. I do realize that the head unit is somewhat old but if there really is some sort of communication issue it must be software related if one device works but another doesn't.
I did some searches but couldn't find anything that approximated an answer so I figured I would try here. Maybe someone has an answer.
r/Chevy • u/Odd-Acanthaceae-61 • 2d ago
Repair Help 2011 CHEVI EQUINOX HELP
Got gifted a 2011 Chevy equinox with a little over 180k miles it’s apparently had an oil leak up front center for years now it’s definitely a puddle she says to top it off every couple weeks what could cause this oil leak? Not driving it at all until I can figure it out. Also what else do I need to look for ?
Discussion Undercoating
Anyone know what kind of u decorating this is? It’s black and kind of crumbly in the wheel wells, on all the front end components and frame rails. Under the body and bottom of frame rails is black and oily. the truck is out of canada and I’m thinking about buying it. The body, rockers, bottom of tailgate are all rust free, nearly perfect.
r/Chevy • u/ElectricalDrop6094 • 2d ago
Discussion My Chevrolet app
Has anyone ever had a problem with their My chevrolet app saying they have arrived at a set alert location when the car was off?
r/Chevy • u/ZachRussell2004 • 3d ago
Picture Back when trucks were trucks!
Just over 3 years ago, I bought my first vehicle, and it was none other than a 1994 Chevrolet Silverado K1500. This truck has been my absolute workhorse.
I am this truck's 7th owner and I have been slowly undoing all the neglect it has had before I acquired the truck. I have done countless research to know more about it.
I'm unable to acquire 100% data to verify its history because no website I have found breaks down the individual SPID codes. But for the information I've been able to acquire, supposedly only 50 trucks were built the same exact as mine?
If anyone is able to help me find out legitimate information to verify this, I would absolutely be appreciative.
Other than that, enjoy this moment to appreciate when trucks were actually trucks!
r/Chevy • u/letsdancetofrank • 3d ago
Picture Anyone got me beat on mileage?! 791,131 mi
2015-2500 Silverado Crew Cab
6.0-original engine, except top end and a cam.
Original differential
Aftermarket built transmission and torque converter
Lucas oil stabilizer from the day I bought it.
I am shooting for a million.
r/Chevy • u/Chancemac678 • 3d ago
Discussion Just got handed down my dads 2003 Tahoe z71
Man I remember riding in this g thang as a young shorty. Now it’s mine. Theres a couple of upgrades I want to make. ( new radio, add a light bar) I’m excited to get started on this project. Any recs are welcomed for anything.
r/Chevy • u/WardogBlaze14 • 3d ago
Picture Spotted this beautiful Monte Carlo in the wild today!
r/Chevy • u/theunsolvedreddit • 3d ago
Repair Help Chain reaction of failures on my '84 Chevy C20: Distributor install ➡️ Carb fire ➡️ Snapped throttle shaft screws. Anyone have a spare Edelbrock/Carter shaft sitting around?
Hey everyone,
I’m working on my 1984 Chevy C20 (350 V8) and hit a massive wall after a wild chain of events this week.
It all started when I was installing my new HEI distributor. I had a backfire while trying to get the timing dialed in, which started a small fire at the carburetor.
After getting the fire out, I pulled the carburetor off to inspect it, clean off the burnt residue, and give it a thorough rebuild. My carb is an Edelbrock AVS2 650 CFM (#1906 with electric choke).
While taking the baseplate apart to clean everything, the tiny 6-32 throttle plate screws on the primary shaft sheared off/snapped inside the shaft.
I’ve been calling around to local auto parts stores and checking online, but Edelbrock doesn't sell just the bare replacement primary throttle shaft through retail channels.
Before I drop $50+ on a used core carb just for one piece, I wanted to reach out to the community here. Does anyone happen to have a spare parts core, an old baseplate, or a good primary throttle shaft from an Edelbrock (1405, 1406, 1906) or Carter AVS/AFB sitting on a workbench that you’d be willing to sell or ship my way?
I’m happy to pay for shipping and toss a few bucks your way for the part.
Appreciate any leads, advice, or spare parts! Thanks guys.
r/Chevy • u/theunsolvedreddit • 3d ago
Discussion Chain reaction of failures on my '84 Chevy C20: Distributor install ➡️ Carb fire ➡️ Snapped throttle shaft screws. Anyone have a spare Edelbrock/Carter shaft sitting around?
Hey everyone,
I’m working on my 1984 Chevy C20 (350 V8) and hit a massive wall after a wild chain of events this week.
It all started when I was installing my new HEI distributor. I had a backfire while trying to get the timing dialed in, which started a small fire at the carburetor.
After getting the fire out, I pulled the carburetor off to inspect it, clean off the burnt residue, and give it a thorough rebuild. My carb is an Edelbrock AVS2 650 CFM (#1906 with electric choke).
While taking the baseplate apart to clean everything, the tiny 6-32 throttle plate screws on the primary shaft sheared off/snapped inside the shaft.
I’ve been calling around to local auto parts stores and checking online, but Edelbrock doesn't sell just the bare replacement primary throttle shaft through retail channels.
Before I drop $50+ on a used core carb just for one piece, I wanted to reach out to the community here. Does anyone happen to have a spare parts core, an old baseplate, or a good primary throttle shaft from an Edelbrock (1405, 1406, 1906) or Carter AVS/AFB sitting on a workbench that you’d be willing to sell or ship my way?
I’m happy to pay for shipping and toss a few bucks your way for the part.
Appreciate any leads, advice, or spare parts! Thanks guys.
r/Chevy • u/Genevieve_Vavance1 • 3d ago
Repair Help Help me fix my car pls
I have a 2018 Chevy Equinox 2.0L Turbo. It has a bad rough idle and vibration specifically in Park, Reverse, and at low speeds, with no check engine light. There is no check engine light. It briefly showed a couple of misfire counts on Cylinder 2, so we already replaced the spark plugs, ignition coils, and oil, and ran Berryman’s intake cleaner twice. The misfire counts are gone, and Berryman’s smoothed it out for a day or two each time before the rough idle came right back. I am being told to have a mechanic check these out Engine and transmission mounts
especially the lower/rear mounts under load in Reverse)
Live fuel trims and a smoke test for vacuum leaks or a failing PCV system
Throttle body carbon buildup (and whether it needs a manual cleaning and electronic relearn)
Intake valve carbon buildup (to verify whether a physical cleaning is actually needed or if the shake is coming from mounts/airflow instead)
But I’m broke as a joke I can scrounge money together for this because well I have to I need my car but I jsut want advice if anyone can offer it
r/Chevy • u/LEXenzo99 • 3d ago
Discussion Tires buy 3 get 1 free - which tires are eligible?
Looking for 225/60R17 on Trailblazer
Does anyone know which tire brands/models are eligible for the promotion?
TIA
r/Chevy • u/Urabus555 • 3d ago
Picture 1991 Oldsmobile Custom Cruiser. My newest purchase.
I'm a Ford guy, have several Fords but I'm excited to have gotten this as I've always wanted a late model b body. L03 305 with tow package.
r/Chevy • u/PreviousProgrammer18 • 4d ago
Discussion 1992 Chevrolet Camaro Rs
hello I’ve actually never have posted on Reddit before but I need help. I have a 1992 Chevrolet Camaro Rs Z03 coded car with 19k original miles. I’m honestly having a hard time trying to sell this thing. Now it’s not entirely a perfect car. The car was garage kept for pretty much the entirety of its like except for the last 2.5 years it was outside under a car cover. The paint is all scratched up and it’s been in a small fender bender from the previous owner. Everything works as it should mechanical besides the A/c and radio. I need some advice on possibly where to sell this thing besides Facebook marketplace or maybe if anyone knows anyone looking for one
r/Chevy • u/Complete_Panic9193 • 4d ago
Discussion Camaro v6 3lt (>2019) or Decked out Canyon AT4 (>2023)?
Im looking into my next vehicle, I'm on track to have ~10k+ down.
the hope is the purchase becomes my "forever vehicle" Based on features (and looks) these are the 2 vehicles I have been considering:
Camaro v6 3lt (>2019) or Decked out Canyon AT4 (>2023)
(as of posting I have test driven an at4, but not a Camaro)
Most of my driving is Highway. Current vehicle: 2001, 340,000 miles, 2wd, v6 F-150.
Happy with the vehicle overall, only dislike is the milage. I will keep as backup vehicle and won't be trading in.
Personal Logical Analysis
Camaro
++ Cheaper by ~10-15k
++ ~+10 MPG
+ "reasonable" car
+ opens door to trackdays and sporty driving
+ "cool" factor
Canyon
+ 4WD (for winter)
+ Is a Truck (can move my own appliances)
+ opens door to overroading (dirt trails to campsites, but mostly a pavement princess)
+ family friendly (if/when i ever get there)
+ opens door to uber/lyft
+ I already know how to drive it ( same physical size and relative feel as my current truck)
+ Towing capacity (trailers/camper if needed/wanted)
+ modern safety features (onlyone that I would miss not having is lane keep)
Personal Emotional Analyses
if camaro
+++ (more) cost effective
+ Door to overroading still exists with old truck
If Canyon
+++ better suited to my current and future needs
Long story short, the Car is a much kinder ask to get started, but the truck can expand with me to most to the future. and want to get general biased opinions from both you and the other subs.
Curious to hear your thoughts!