r/flashlight • u/jq910 • 11h ago
Discussion Differences in newer Wurkkos FC11Cs
I recently bought a couple of FC11Cs from the Wurkkos Official Store on Aliexpress to mod and noticed that they had a couple of design differences compared to the one that I bought from Amazon during the summer.
The most significant change is in the switch. The retaining ring for the button on the new FC11C is now press fit which is disappointing. I'm not sure if the driver can be easily removed and replaced anymore since the button PCB assembly needed to be removed to push out the driver on the old version.
The new switch feels a lot more consistent and can be pressed from any point on the switch compared to only directly over the small SMD button on the old version. It's like it already has the popular FC11C button mod done to it.
The design of the driver has changed as well. The new driver has two protrusions on the PCB which probably makes it incompatible with old FC11C hosts without the cutouts for the protrusions.
The new FC11C has a longer delay from pressing the switch to the light turning on or off. It feels less responsive compared to the old FC11C. There is also an interesting quirk where trying to use moonlight mode after using turbo causes a quick bright flash before actual moonlight mode. The old FC11C does not do this.
There is also a difference in the OP reflectors. The newer one is smoother with larger "grains" compared to the old one with is less smooth and has finer "grains". I feel that the older fine grained reflector made less artifacts around the hotspot compared to the newer smoother one, but I'm not 100% sure.
The edges on the new FC11C feels sharper in the hand compared to the old FC11C. There is also a weird notch behind the front bezel which I'm not a fan of. A lot of glue was present in the threads of the bezel on the new FC11C. I had to run it on turbo to heat it up and wrap duct tape around the bezel to get enough of a grip to loosen it. I did not have to do this on the older FC11C.
Note: Ignore the beam pattern, tint, and CCT difference in the gifs. I've swapped the emitters on these lights. The orange one has a dedomed 5700k 519A with a 15 degree TIR while the black one has the stock OP reflector with a 5000k sft-25r.