r/KTM • u/AmazingLaugh5030 • 21h ago
ALL Engine Rebuild on a 2014 duke 690
(first photo is picture from previous owner, second is metal shavings in the bottom of the case
I purchased a 2014 duke with an interesting background, to shorten it to the important part it needed a rebuild before I had it and the previous owner took it to shop that got part way through rebuilding it when the shop closed they slapped it back together quickly and gave it back to him. I have taken the top end apart and going through the engine. I have confirmed the cylinder and piston are both in spec, along with the valves seal properly.
As I dig deeper into the bike I have noticed a few things I noticed that the piston that is in the bike doesn't match the photo of damage he had originally sent me, I believe it is a newer piston and its still in spec but does have some wear. I was told that the reason the shop wasn't able to finish the bike was that they weren't able to replace the connecting rod bearing because they didn't have the tools (which seems odd). When testing the connecting rod it seems ok as there is no up and down play and minimal side to side play I can see small metal shavings in the bottom of the case and I'm assuming that I should split the cases but would prefer not to if avoidable. and if I split the cases do I need to replace the bearing if it seems to be good.
also the cover plate in the last photo seems to be a bit bent not sure if that's normal or not.
also if there is anything I should check while working on it that would be much appreciated?