Hi! I'm new to lino printing and have been really enjoying it, but having a slight issue that I'm hoping someone could please advise on!
I'm using SoftCut lino and the Essdee beginners set (the red-handled tool with the blades you can swap out).
I'm finding the small V-shaped cutter easy enough to use when starting a cut on untouched/uncarved lino, but I'm struggling when trying to start a cut from an already cut edge/wall.
Basically: I've carved out a triangular area (as in, carved around the edge so a triangle remains), and now I want to make a straight cut across the middle of that triangle, essentially splitting it in half. I'm trying to start the new cut from one of the existing cut edges/walls, but the V-tool just seems to slip rather than bite into the lino!
I wondered whether it's an issue with the depth or angle I'm holding the tool at, or whether there's a particular technique for starting a cut against an existing carved edge? I've tried starting at various angles/depths on a scrap piece but struggling to find something that works. I've also tried doing two cuts starting from the middle, but then the line doesn't seem as clean. Could it be because they're cheap cutters so maybe not as sharp? Or is it the depth/pressure/angle/something else? (Am I a poor workman and/or should I blame my tools?)
Is this a common problem? I couldn't find anything specifically about this issue online, so any tips would be really appreciated! Thanks in advance! :)