r/Masks4All • • 1h ago

Elastomeric Respirator for Small Face, Glasses (part 2)

• Upvotes

Hi all. I'm looking for advice in finding or adjusting a fitting reusable respirator. I'm having trouble getting a good, consistent fit, and I assume it's due to my small face. I use these when I'm at home and shopping. Here's what I've tried.

Disposables:

  • 3M Aura is too big on me.
  • Gerson 3230 is better, and I wear these around the house.
  • 3M 9105S is better as well, and I wear these out.

The glasses fog/potential bad fit around the nose are starting to drive me nuts though. As well, I would like less breathing resistance.

Reusables:

  • 3M 6100 series small was too big.
  • Envo Mask was kind of uncomfortable in general and I felt like I didn't get a good seal either.
  • GVS Elipse in small felt good, but when I took it in for fit testing they said it gapped too much under the chin.
  • MSA Advantage 900 in small gave me a good fit test result, but when I wear it for longer than about 50 minutes, the part where the straps snap together digs into the top of my head and gives me a massive headache. I'd be open to modifying this mask as well as looking for a new one.
  • MSA Advantage 200 in small seemed to fit nicely, but I REALLY did not like the sensation of fighting the valves to inhale and exhale. I prefer source control or perhaps I should be looking into PAPR?
  • Dentec NxMD in small fit well for about 6 months and then it started gapping at the sides. Liked it while it lasted, but is that what I should expect?

Poking around a lot on various websites, but I'm not sure what to try next. Any advice?