For a while now, I've been trying to figure out a way to calibrate my Polaroid SX-70 cameras without having to use so much film in the process. Film is pretty expensive in my country, and that makes the whole calibration process quite frustrating, especially when converting cameras to use 600 film. Swapping capacitors and adjusting the solenoid involves a lot of trial and error, and i once went through almost an entire pack of film trying to calibrate a single camera, and I still wasn't completely satisfied with the results. I know that a lot of this comes down to experience, and I'm sure I'd get better at it over time, but learning through trial and error gets pretty expensive when every shot costs money.
So I decided to try making something that could help standardize at least part of this process. My goal is to have a reference that I can use when calibrating the cameras I restore, instead of having to rely almost entirely on film to figure out whether my adjustments are correct. Ideally, I'd be able to do most of the initial calibration with this device and only use film for the final tests before sending a camera back to its owner.
The project itself is nothing special or revolutionary. There are plenty of similar shutter speed testers out there, and I basically took an existing concept and modified some of the code to add a display and a few extra features. This first version is extremely basic, pretty much just a proof of concept to see if the idea would actually work before spending more time improving it.
Since the SX-70 uses the same shutter blades to control both shutter speed and aperture, in theory (i think), the same shutter speed should also result in the same aperture, or at least something pretty close to it. I'm not 100% sure about this, but that's basically what I'm going with for now.
As for accuracy, I'm still not entirely sure. At least when it comes to repeatability, the results seem pretty promising. When I take several measurements under the same lighting conditions, the device consistently gives me pretty much the same reading. But whether those readings are actually correct is another story. I tried testing it with one of my 35mm cameras, and at slower shutter speeds, the results were pretty close to what I expected. However, starting at around 1/250s, the measurements began to differ quite a bit from the selected speeds. The problem is that this camera has never been serviced, so I have no way of knowing whether the issue is with my tester or if the camera's shutter is simply out of adjustment. And since I barely shoot 35mm, it's the only camera I have available for comparison.
Right now, I'm planning on working on two SX-70s to use as reference: a Model 1 and an Alpha. I chose these two because their shutter blade designs are different, and I suspect that might affect the measurements. The idea is to get both cameras properly calibrated and exposing correctly on film, then use them to record measurements under different lighting conditions. Hopefully, this will give me a set of reference values that I can use when calibrating other cameras.
I still have a bunch of things I want to improve. One of them is adding an adjustable light source for the Electric Eye, so I can test different lighting conditions without having to rely on whatever light is available.
Anyway, this is all still pretty early, basically just a proof of concept to see if the idea actually works. I'm not sure if it'll turn out as well as I'm hoping, but so far it seems promising.
If anyone has any ideas or suggestions, I'd love to hear them! I'm sure there's plenty of stuff I haven't thought of yet or things I might have gotten wrong.