r/Revopoint • u/jetdillo • 2h ago
Revopoint Metro Y Ultra laser stalls/disappears
I'm running into an issue with my new Revopoint Metro Y Ultra and could use some help. I'm not sure if this is a user error on my part, actual problem with the scanner or function/bug of the Metro software.
I'm scanning a lot of "black" objects: embedded, ruggedized servers, LIDARs, Depth Cameras, etc. all in black anodized or powder-coated IP6x-rated enclosures.
So I'm using the crossbeam laser mode, high-res capture with the object type set to "Black". I've noticed that it takes a couple thousand frames to get a good solid scan of one side. Sometimes the cross-hatch pattern disappears, the frame rate drops from 90+ FPS to 50 or less and the scan basically grinds to a halt. If I move the scanner off-target, the laser seems to "wake up" again for another minute or so, comes back up to speed but then starts crawling again.
I'm not moving the scanner during this time. It's on the tripod, locked down, just painting away on the target.
Is the laser only supposed to run for so long ? Is it maybe overheating ?
Does this mean that it's finished that face?(The preview dialog says something about "Continue scanning until object turns blue") Should I always be moving the scanner around and just come back to places I want more coverage on ?
Thoughts ?








