r/sdr • u/mustang6139 • 5h ago
Measured gain / front-end behavior on a few SDRs
I put these measurements together for myself while working on support for these radios and figured they might be useful to others too.
This is still going to grow. I need a proper spectrum analyzer and I already ordered a 50 ohm attenuator.
Measured the actual gain behavior on the Airspy R2, HF+ Discovery, SDRplay RSP1B and PlutoSky R2 I have. All numbers are from my own tests with a HackRF as the source.
Not a calibrated instrument, but it might still be useful. Results are specific to the exact boards and firmware I used.
The attached image shows the Plutosky R2 measurement
A few things that stood out:
- Airspy R2: LNA is strongly frequency-dependent. Usable top is around -3 dBFS (clips in the IF before the ADC).
- Airspy HF+ Discovery: clear hold/limiter after the attenuator.
- SDRplay RSP1B: LNA states diverge from the published table by several dB. In some states, more IF gain below ~23 dB reduction actually reduces the signal (mixer trap), and the AGC ends up 5–10 dB short.
- PlutoSky R2 (PLUTOSKY-R2-9361-NOPA): cumulative gain error reached -5.6 dB at 71 MHz.
Full write-ups:
If you have one of these and feel like measuring more (or repeating the same tests), the docs are open for PRs.