r/XboxModding • u/Protest_The_Gyro • 12h ago
OG Xbox Finally Have a Solution to my 1.0s Crashing at HD Resolutions / With HDMI Mods
After trying many potential solutions, I finally have clean pixel clock signals on my 1.0 XBOXs.
In certain situations, when outputting 720p+ on a rev 1.0/1.1 xbox, noise on the pixel clock output from the GPU causes a missed edge on the buffered clock output from the analog video encoder. When this happens, the GPU crashes, freezing the whole system. This seems to be more of an issue when using an HDMI mod, as the pixel clock line is extended allowing for additional interference, though, it happens using component cables as well.
The QSB with the MakeMHZ kits attempts to address this, by implementing the same thevinin termination found on later revision motherboards. There are a few problems with this:
- the termination happens much further from the receiver (video encoder) than on later revision boards. On 1.2-1.4 boards, the terminating resistors are extremely close to the video encoder. CLKIN has a via very close to the pin, which leads directly to the terminating resistors on the bottom side of the board. The QSB does his a bit further away.
- 1.0/1.1 motherboards generally do a very poor job at shielding the clock signal. If you look at the clock signal on a scope while in UIX Lite for example, you can switch the skin between default (green), blue, and red, and see a noticeable shift in the distortion of the clock signal. In my experience, large amounts of blue on screen are most likely to result in a missed edge due to poor shielding from the digital video data lines. This does not occur to nearly the same degree on later boards, but does s
t
- ill dramatically occur even with the termination provided by the QSB.
I tried different forms of termination at the encoder, and on the HD+ board itself, and while I was able to improve stability, you could still see the interference on a scope and the system would eventually crash.
The solution, that has been rock solid on a few of my systems has been to bypass the original clock trace all together, skipping QSB termination.
- Cut GPU CLKOUT / Encoder CLKIN close to the GPU.
- Bridge gap with 47R 0201.
- Cut out trace about the resistor to eliminate original routing of clock signal
- Cut trace near video encoder.
- Re-run CPU CLKOUT / Encoder CLKIN with 36AWG 50ohm coax. Ground shielding at via near bodged in resistor near the GPU on one end, and at the ground via connection to pins 50 + 51 on the encoder.
- Replace 0R resistor a R4B3 with a 47R 0603.
- Make sure nothing moves and rips up a trace with some UV cure solder mask.
Clock signal is now as clean as on later revisions (unfortunately, having issues getting captures on my scope at the moment, so I can't show comparisons, but I assure you it is much much better).
Figured this might be helpful for those stuck with their 1.0s. I know many would just opt for a different revision, but personally, I started doing CPU upgrades and what I had to work with, were 1.0s, and really wanted my 1.4GHz systems to not be crashing at 720p... Maybe others are in a similar boat.
Edit: PS, please ignore any sloppiness, this is my test system, and a lot of nonsense has been tried on this motherboard.