r/computervision • u/mehdi-33 • 5h ago
Showcase 2-axis gimbal. Solo engineered. Master's thesis.
I'm building a 2-axis gimbal with a visible and a thermal camera for a small fixed-wing drone, as my master's thesis. The clip is the CAD model: on the left the gimbal as it looks, on the right the same unit with the housing made see-through, doing the same moves.
I'm posting here because the mechanics are mostly settled and the vision side is where I'd like input before I freeze the hardware.
What the cameras get from the gimbal:
- Two cameras in a 67 mm ball, one above the other: a 5 MP visible camera and a 256×192 thermal camera, both arriving over USB
- Two axes, roll and tilt: ±100° in roll, and from 25° up to 95° down in tilt
- A magnetic encoder on each axis and two IMUs, one in the ball and one in the base, so the pointing angles are known at any time
- Around 187 g for the whole nose
Two things I already know will matter for the image processing:
- There is no pan axis. To look sideways the ball rolls and then tilts, so the picture rotates with the roll angle and has to be turned back in software.
- The two lenses don't share an optical axis, and the thermal image is far lower in resolution, so lining up thermal and visible pixels will need calibration.
Questions for anyone who has worked with visible and thermal pairs, or with cameras on gimbals:
- Is there something you wish the hardware had given you? Frame timestamps tied to the IMU, a sync line between the two cameras etc...
- For registering thermal to visible at this resolution is a fixed calibration enough at long range or do you end up correcting per scene?
Thx!
- Amine Mehdi M.
