Built the above and having issues with oscillation while at max volume and above about 7 gain. Rolling back to 6-7 volume allows me to max the gain with no oscillation. Rolling the treble all the way down delays the onset of oscillation slightly.
All tubes are running well within datasheet specs, and the bias of everything is textbook. The output tube is biased to 75% max dissipation.
The power supply is an inverter I have used multiple times before, and there is less than 30mv of ripple at idle @ 60khz. There is zero ripple on the regulated DC heater wiring.
All the common oscillation issues I've tried and have had little to no impact:
- preamp/power amp grounds are separated, and tie directly to the chassis at a single point that's star washered over solder. There is <0.5R of resistance between any grounded points.
- I added an extra stopper to U1A right against the grid and it make no difference.
- I added a small 100R stopper between DC coupled follower (as per Merlins suggestion to prevent oscillation). No difference.
- R8 and R15 were originally 10k. Increased to 150k with no difference in noise.
- thinking the slightly longer trace between R8 and the grid of U3A could have been a culprit, I decoupled with a 47pf cap. Made no difference.
- shifting any offboard wiring around makes zero difference EXCEPT that the wire for pin 3 of the gain pot (and that side of the bright switch) is massively microphonic (nothing else on the board or tubes are microphonic).
- no amount of moving/rewiring/shifting the bright switch made any difference. Removing it entirely decreased oscillation slightly but it is still there.
- once the bright switch has been removed, the gain pot wires are no longer microphonic but moving my hand nearby suppresses oscillation slightly.
- changing these wires to shielded mic cable makes no difference
- no amount of copper shielding between the tubes, chassis or power board make any difference to the oscillation.
It appears something between the follower and U3A is causing the oscillation, but for the life of me I can't figure out what it could be.
Any suggestions?