I have watched many videos and read many post and as far as I can tell 32-bit float/dual ADCs has no or possibly small advantage.
It seems to me that as long as the ADC can cover the full dynamic range of the front end at a fixed gain and has sufficient resolution there's no benefit. The only possible benefit is better resolution.
If the signal exceeds the input electronics levels then no number of bits can correct this.
Switching high levels to a second ADC effectively increases the number of bits but 24 bits has always seemed enough.
As I see it the real benefit is that by fixing the gain the EIN must be low, so that it will not be a problem in post after amplification, and the full dynamic range can be converted.
The 32 bit float is the way it is stored on file which has a benefit of compatibility.
Shoot me down in flames if you wish, I'm here to learn.
Edit
Thank you all for your comments and explanations.
This is what I have learned and I think I've sorted my confusion on some points.
As we all have seen most 32-bit float devices have a fixed gain and a very low EIN.
To achieve the very low EIN, the primary analogue/ADC chain must be kept at an "optimum" gain. By fixing this the EIN will the be same across all signal levels.
Also this gain level will not cause analogue clipping within the manufacturers specified dynamic range.
The reference for the primary ADC will be chosen to give the lower bits of output.
The second ADC is used for the higher levels to give the "headroom" and will be given a reference to give the upper bits.
The two ADC's outputs are then mathematically merged and converted to 32-bit float for file storage and post.
Part of my confusion was "optimum gain" vs "highest gain" and "headroom". It is commonly said that the lowest EIN occurs at the highest gain, but my experiments on the Sony A10 shows that the EIN changes by about 1dB from gain setting 15 to 30, that's from 30 to 60dB gain. So the highest gain for the lowest signal is not needed for the best SNR.
Also my original premise that
as long as the ADC can cover the full dynamic range of the front end at a fixed gain and has sufficient resolution there's no benefit
is valid BUT the reduction in gain needed would cause pre-amp noise issues. Just like running at low gain levels and adding gain (and noise) in post.
The term "32-bit float" is kinda meaningless wrt the analogue quality, but dual ADC/fixed gain is a way of optimising the pre-amp gain EIN and giving headroom/dynamic range.
In practice the fixed gain and headroom make it very valuable in unpredictable sound level situations as mentioned below.