r/functionalprints • u/Particular_West6314 • 9h ago
r/functionalprints • u/TechMan_SA • 18h ago
Organisation / Storage My wife wanted a spice rack, so I designed and 3D-printed one that pulls out and folds down!
r/functionalprints • u/RadishRedditor • 6h ago
Electronics / Mounts / Enclosures I Made this JetEngine nozzle for my Wolfbox MF200 - a Venturi nozzle that pulls in room air. Ran it through CFD Simulation before printing
I wanted a nozzle for my Wolfbox MF200 that moves more air without losing push, so I went down a bit of a rabbit hole.
It's two parts. The core clicks into the duster and squeezes the fan's air into a tight 19.5 mm jet. The shroud twists onto the core, and that jet drags room air in through the 8 vanes at the back. Both streams mix in a 29 mm tube and leave the tip together.
Before printing anything I ran it in CFD (OpenFOAM, same fan curve every run) and compared the core on its own against core + shroud:
+36% air leaving the tip
+24% at 5 cm
+15% at 15 cm, +8% at 30 cm
push basically unchanged (232 g vs 238 g in the sim)
the fan even works against a bit less back-pressure with the shroud on
Quick honesty bit: a venturi can't add push. Momentum is momentum. What it adds is volume, so you move more air with the same thrust, and the gain is biggest up close where you're actually dusting. I'll run proper scale tests on this version and post them.
Other stuff I cared about:
1° taper on the mount so it presses in and seals, plus the bayonet click
30° twist-lock between core and shroud. Clicks shut, no tape, no rattle
One plate. Core prints bayonet end down with supports only under the centre hub, shroud stands on its tip with no supports
Profiles for every Bambu printer at 0.16 mm. Mine's gray ABS on a P1S, PLA works fine too
Free on MakerWorld: https://makerworld.com/en/models/3637893
Video of it on a pile of leaves is in the comments. Happy to answer anything about the CFD or the design, and if you print one I'd love to see it.
r/functionalprints • u/Kevkevkev888 • 10h ago
Home / Furniture / Household Shark WV200 & WV251 Cordless Handheld Vacuum Nozzles
galleryr/functionalprints • u/mariuszmialpsa • 6h ago
Organisation / Storage Parametric, stackable screw organizers with a spot for NIIMBOT labels
galleryr/functionalprints • u/andtdev • 4h ago
Home / Furniture / Household I made a stand out of flat links with hinges that stay locked until you squeeze them. Everything is printed, even the springs.
galleryr/functionalprints • u/OneButterscotch2691 • 5h ago