r/led • u/mblevels • 15m ago
Flickering LED strips - power injection and power supply advice
Hi all,
I've been setting up 5V SK6812 LED strips with 60LED/m density, but I'm having some power issues. My setup is in the screenshot below - red shapes are the strips, yellow shapes are power supplies with ESP32 controllers and orange shapes are WLED segments (with start and stop LEDs) - I've named the segments by the controller they're connected with (Fink, Wendy, etc). I've optimistically set this up without power injections and found out this doesn't work well. The issues I have:
- The tail end of Fink Balk 2 is flickering
- All of Wendy is flickering on many effects and changing settings happens slowly and in very discrete steps
- Setting the brightness of Wendy above 20% or so causes the power supply to audibly whir. As I increase the brightness, it gets louder. I've swapped out my power supply for another one and it has the same issue.
My questions:
- How much power injection should I be doing (and where) along the Fink and Wendy to fix the voltage drop issues? Online recommendations seem to indicate every 0.5-1m or so, but the Mark, Bobby and Lisa strips are in the 1.5 - 2m range and don't have issues. I don't need to be running these at full brightness, I just want to solve the flickering.
- AI is telling me the whirring is caused by the power supply being close to its limit. Does anyone know if this is true? The power supply is 5V/20A and the max current needed according to WLED is 55mA * 308 = 17A, but I'd be surprised if it reaches that due to the voltage drop issues and limiting in WLED. Also, the whirring starts at low brightness too. Would upgrading the supply to e.g. 30A or 40A make a difference, or is there a different issue?
Thanks in advance for your help!

