You're out camping in the winter where overnight temps get cold enough that your fridge doesn't cycle all night. The next morning you drive off, blissfully unaware that your electrical system has shut down and is not recharging from solar as it should be. If this situation sounds familiar, you're not alone, and I came up with an automatic solution for the problem. You'll need a 3d printer and some basic soldering skills and depending on what you have on hand somewhere between $5 ad $30 in parts.
My solution is small keep-alive device. A timer relay closes a switch for 30 seconds every 20 minutes, and the switch connects a 30 ohm, 10 W resistor across the station's 12 V DC port. My 12.7 V system the station's display shows 6 W during each pulse: about 5.4 W through the resistor plus about 0.6 W for the timer board while its relay is energized. Averaged over time, the total draw is around 10-15 watt hours per day total..
The complete build instructions and parts list are attached as a PDF.
The print files can be found at https://www.printables.com/model/1916768-keep-alive-device-for-12v-power-stations
I included the raw CAD files in case you want to modify the enclosure for a different resistor or fuse holder. It looks more complicated than it is - anyone with basic soldering skills should be able to make one. (Cross-posted from Expedition Portal )