My initial runs with this system were fraught with bolt binding, stuttering rhythm, failures to fire & eject, etc. It was a lot of frustration, tinkering and more wasted ammo than I’m ready to admit. It seemed pretty obvious the main sear spring was binding within the actuator and so I mentioned this to AOK through email before sending them my hammer pack. They returned my pack freshly lubricated - which it already was - but made no alterations or replacements. The system ran much worse when I got it back. So here’s what I did myself to finally get this system running.
•Dremeled and polished a relief cut in the actuator
•Installed the K&M Lightening Spring. I still felt binding with the OEM spring despite a generous relief cut and didn’t want to remove any more material from the actuator. Combining the relief cut with the new spring made the difference
•Added a pair of 3D printed overtravel stops provided by a heroic fellow redditor; thank you. After some shaping these fit right in the channels. With the current length of pull, the disconnector just clears the path of the hammer so I’m thinking I reached the lower limit of wasted motion
•”Tuned” the mating between the hammer spring and the out of battery sear. The sear seemed stiff which probably contributed to a few of my dead triggers. I gave the hammer spring a bit of persuasion and it works with the sear much better. I’m guessing I tweaked the spring in the course of disassembling and reassembling my pack over and over again trying to make this work
Your results may vary. Maybe this will help you or perhaps yours ran perfectly out of the box. Before some of these fixes I got smooth and fast operation with the help of one of my cans but unsuppressed fire was a mess. Now it runs nice and smooth in either configuration. I wish AOK would’ve listened to me when I suggested the actuator needed a cut. They kept going on about the chamber potentially being dirty or my trigger pressure being too high. I told them the chamber got the white glove treatment before every test and I was being as mindful of my trigger pressure as could reasonably be expected.
If you’re working on this system yourself, hopefully this post helps you waste a lot less ammo than I did.