Hi everyone!
What I'm trying to achieve
Ideally, after the initial setup, I would only need to launch Seedsow and trigger the kaiHEN chain again, without going through SmileBASIC, keyboard input, PC commands.
What do I have (requisites?):
- Nintendo Switch 2 on firmware 23.0.1
- No supernag
- SmileBASIC 4 purchased
- Seedsow Lullaby demo installed
- MicroSD update installed
Here's the chain I'm considering:
1. Establish an offline connection between Switch 2 and PC
https://github.com/fernando-granco/switch2-ethernet-offline
Use the local connection-test emulator to establish a wired LAN connection without exposing the console to Nintendo's servers and a supernag.
2. Run ns2jb through SmileBASIC 4
https://gitlab.com/kurumuz/ns2jb
Use kurumuz's fork to obtain the initial FS access on firmware 23.0.1.
3. Install the Artemis launcher save into Seedsow
https://github.com/dougchansan/ns2-savekit
https://github.com/alula/switch-artemis-launcher
Use the ns2jb session to back up the Seedsow save and install the Artemis launcher, giving me a reusable entry point through the demo.
4. Launch kaiHEN through Seedsow
https://github.com/Malev0/seedsow-fs-kaihen
https://github.com/ouncebrew/kaihen
Use the Seedsow FS implementation to launch kaiHEN, then open hbmenu using a native Switch 2 game while holding R.
Questions
I understand seedsow-fs-kaihen needs a pc every launch and it's the only missing piece to achieve semi-tethered?
Is it possible to autolaunch kaihen with seedsow? I have smile basic so I understand if anything goes badly I can reset this seedsow-automatic-launch?
Thanks!