Long story short, I installed a Dobinsons lift a little over a month ago in my garage. It was my first time doing any suspension work myself, and I followed the instructions carefully (didn’t torque my lower control arm bolts until I had the weight of the vehicle on the ground). Got an alignment before driving and have put about 1,600 miles on the car since. About a week ago I began to hear a single clunk noise coming from my front left when braking. Shortly after I began to hear it when accelerating as well, and would hear it when accelerating and turning to the left. I was finally able to get a video of the suspension components and noticed that my lower control arm is shifting (ignore the markers on the cam tabs, they shifted right before this video when I tried to tighten the bolts to see if the clunking would stop).
I’m guessing my bushings are shot - so trying to find out what to do from here.
I’ve read that Toyota recommends replacing the lower control arm unit as a whole when bushings go bad. If I were to do that, would I need to replace both front lower control arms or is it okay to only replace one side as needed?
My buddy has a press and said he would help me install new bushings, but I’ve read that it’s hard to get the old bushings out and new bushings in. I’ve also read that a lot of aftermarket bushings require maintenance to keep them from squeaking which I want to avoid. Is it worth buying oem bushings and trying to replace them myself?
Bummed that I have to fix this after only 30k miles on the car but it’s more than likely user error on my part - not the most mechanically inclined haha.
Appreciate any input!