so I'm continuing with this build: Link to previous post
This time I have real hardware to show, a few things that didn't go to plan, and a question for you at the end.
Where it stands: last time, the boards only existed in KiCad. Now they're made, and the first half is partly soldered. That's picture1 is the render of where it's heading. You can see where I am taking the project , and at what phase it is right now in picture 2 and picture 3 . I planned to print the case next, but that didn't work out. The USB-C boards I bought for the module docks are more than twice the size I designed around, so the case is getting one more revision first (refet to Picture 4).
What I learned on each part:
Trackball: my first design had its own battery and controller, and it ended up twice as tall as the keyboard. So I took both out. Now the keyboard powers it through the dock, and it sits level with the case. It's also one less thing to charge.
Boards: I changed the trackball after the boards were finished, so they don't carry its wiring. I'll add one diode and four wires by hand on each half. Lesson learned: settle the modules before ordering boards.
Power: I looked at cheaper ESP32 controllers. By my estimate, they'd empty a battery this small in about a day, so I stayed with the nRF52840. I also dropped charging through the docks for this first build. It charges through one USB-C port, which means fewer parts and less wiring.
I've also put the 3D render on a page, if you want a closer look: https://www.kinsetkeys.com/render
What's next: finish soldering both halves, revise the case, then start on the firmware.
One thing I'm still deciding is the battery. A bigger one lasts longer, but it takes space I need for the docks. So here's my question: how often do you charge your wireless keyboard now, and how often would start to annoy you?