r/ECE • u/ChinaChipChat_ • 8h ago
PROJECT What electronic components are actually inside a domestic Chinese EV? Xiaomi SU7 headlight driver teardown
People often ask what parts actually go into domestic Chinese EVs, so I tore down a Xiaomi SU7 front headlight driver module to see. The back cover looked plain compared to an all-metal Aito M7 unit I opened earlier, almost like a knockoff at first, though that is just how these are made. Heavy glue between the bottom shell and metal front cover forced me to break the back housing apart to get the single-sided PCB out, which only has one external connector on the back.
The board runs on an Infineon CYT2B75CADQ0AZEGS Arm Cortex-M4 automotive MCU for lighting logic, PWM, diagnostics, and protocol stacks, paired with two NXP CAN transceivers—an SOP8 TJA1042 for body network comms and an SOP14 TJA1043 supporting 5 Mbps CAN FD for higher-bandwidth dynamic lighting data. Power and beam control use an MPS MP2019 linear regulator for 12V transients and low quiescent current, an ON Semiconductor NCV70517 microstepping motor driver for AFS adaptive beam adjustment, and a ROHM BD42530 voltage follower with ±10mV offset to track voltage and offset cable drops.
TI chips handle the LED drivers across primary and auxiliary circuits: a TPS92682Q dual-channel constant-voltage LED driver with PWM dimming paired with Diodes Incorporated DMPH4015SPSQ MOSFETs and Good-Ark AMBRP10H100 Schottky diodes for main LED strings, plus three 1.6A TI TPS92520Q dual synchronous buck LED drivers for auxiliary lights like DRLs. There is also another DMPH4015SPSQ P-channel MOSFET and an unidentified SOP8 chip marked 2LZ15.
Overall, the BOM mixes established international suppliers for core control, bus interfaces, and LED drivers with domestic parts like Good-Ark on discrete power components, sitting at the opposite extreme of the Aito M7 hardware setup I saw before.