r/ToobAmps • u/Left_Yam_1456 • 8h ago
r/ToobAmps • u/NAVI_WORLD_INC • 21h ago
This project took me almost 2 years to get together and oh boy it’s a monster.
r/ToobAmps • u/GuitarBombDotCom • 15h ago
Bad Cat Unveils Unleash V3: 150W Attenuator & 100W Re-Amp
guitarbomb.comBad Cat Unleash V3: 150W attenuator + 100W re-amp hybrid. Control tube amp tone at any volume. $799.
r/ToobAmps • u/tidalflats • 23h ago
Random pix of half-finished amp
galleryI was hoping my big box of parts would come in early enough today to get some wiring work done. But it came 10 minutes before I had to start cooking dinner for the wife. So after dinner I did some minor assembly work and apart from testing OT orientation noise I'm ready to start wiring tomorrow. Not expecting any issues and it should be alive by tomorrow night. This is a Fender Deluxe 5e3 in a Princeton Reverb-size chassis I'm building for a fellow Redditor. Psyched for faceplate's arrival tomorrow too.
r/ToobAmps • u/tidalflats • 9m ago
It lives!
galleryMostly finished wiring up the 5e3 today. Love this circuit, the interaction between the volume controls is wild.
Things went to plan today after they didn't.
First order of business this morning was to fine tune the output transformer placement to minimize transformer hum.
This is accomplished by applying power to the installed power transformer (all secondary windings taped off), then getting a pair of headphones and hooking them up to the OT secondary. With the PT under power you can usually hear hum as you move OT closer to PT, and less as you back it off or rotate it etc.
I should note that in its original placement I had the PT oriented the way it was done on the original 5E3, which coincidentally is 90 degrees from the way it was done in blackface amps like the Princeton reverb.
Anyway, Usually the little headphone technique allows you to find a very quiet spot to place the OT. This time though, I could not find a spot that didn't produce at least a small bit of hum. Any hum is my enemy, even a little. I hate noise.
So I grabbed another blank chassis, cut it all out and installed the power transformer perpendicular to the way it was originally oriented.
This did the trick and I quickly found a hum-free spot where I expected one to be.
I could have just cut a new hole in the original chassis but clean work is important to me and I hate holes that don't need to be there. So I was happy to chuck it and start from scratch.
From there it was a few hours of wiring and the amp is in business. Still a few more things to do but finish line is approaching.