Mostly finished wiring up the 5e3 today. Love this circuit, the interaction between the volume controls is wild.
Things went to plan today after they didn't.
First order of business this morning was to fine tune the output transformer placement to minimize transformer hum.
This is accomplished by applying power to the installed power transformer (all secondary windings taped off), then getting a pair of headphones and hooking them up to the OT secondary. With the PT under power you can usually hear hum as you move OT closer to PT, and less as you back it off or rotate it etc.
I should note that in its original placement I had the PT oriented the way it was done on the original 5E3, which coincidentally is 90 degrees from the way it was done in blackface amps like the Princeton reverb.
Anyway, Usually the little headphone technique allows you to find a very quiet spot to place the OT. This time though, I could not find a spot that didn't produce at least a small bit of hum. Any hum is my enemy, even a little. I hate noise.
So I grabbed another blank chassis, cut it all out and installed the power transformer perpendicular to the way it was originally oriented.
This did the trick and I quickly found a hum-free spot where I expected one to be.
I could have just cut a new hole in the original chassis but clean work is important to me and I hate holes that don't need to be there. So I was happy to chuck it and start from scratch.
From there it was a few hours of wiring and the amp is in business. Still a few more things to do but finish line is approaching.