r/TpLink • u/zorppppp • 18h ago
TP-Link - Technical Support BE63 Constant Drops
I've been troubleshooting some very strange home network issues over the past few days and could use some advice.
Network setup
- ISP: Xfinity
- Modem: Personally owned, separate from router
- Router: TP-Link Deco BE63
- Multiple Deco satellites with wired Ethernet backhaul
- Multiple Macs, both wired and wireless
Symptoms
Started Monday, right around the time we had some electrical work done (coincidence?), which did cause the decos to shut on and off, since then:
- My wife and I both experience intermittent freezes during video meetings, using different Macs in different parts of the house.
- Connection can work perfectly for 30–60 minutes, then suddenly experience severe packet loss or a complete interruption for several seconds.
- Wi-Fi remains connected during the freezes.
- Wi-Fi: Frequent latency spikes when pinging the router directly, sometimes hundreds of milliseconds, plus occasional packet loss.
- Wired Ethernet: Generally very low, stable latency to the router (around 1 ms), but intermittent complete dropouts have also occurred.
Troubleshooting
- Reproduced problems on at least three different Macs.
- Both wired and wireless connections have experienced issues.
- Rules out a single computer as the likely culprit.
- Continuously pinged router (192.168.68.1) and external IP (1.1.1.1), latency and drops on both.
- Observed significant Wi-Fi latency spikes when pinging the router by itself.
- Observed packet loss to both router and external IP during certain outages.
- Wired connections can be perfectly stable for extended periods before suddenly dropping.
- Disconnected all Deco satellites, disconnected downstream Ethernet switch, tested with only the main Deco and Wi-Fi latency spikes persisted even with satellites disconnected.
- Connected a Mac directly to the Xfinity modem, bypassing the Deco. Results were clean
- Replaced the router with another brand new BE63 I had in a box, BUT I restored from cloud backup, not factory reset or firmware roll back - could be next step
- To rule out some weird electrical issue, I turned off the circuits I had worked on; network problems continued.
Next steps I'm considering
- Factory-reset the Deco and create a completely fresh network configuration.
- Test wired and wireless performance before reconnecting satellites or switches.
- Potentially roll back the Deco firmware if supported.
- Test with a different router brand.
Is there anything I should look into or troubleshoot?
Any suggestions would be appreciated!