r/openwrt • • 11h ago

Cudy WR3000P (SN 2624) – WAN port dead / not recognized on OpenWrt, forcing LAN fallback. Any fixes for newer hardware revisions?

2 Upvotes

Hi everyone,

I recently installed OpenWrt on my Cudy WR3000P v1 (EU version), specifically unit with serial number starting around 2624.

As known from some other Cudy/MediaTek devices, the 2.5G WAN port (which also handles PoE-in) is giving me a hard time. On a fresh OpenWrt installation (25.12.5), the WAN port remains completely dead—no link, no reaction to the cable, and dmesg | grep -i eth shows no eth interfaces at all (only the internal switch and wireless interfaces).

Right now, I am forced to use a workaround by using LAN 1 as a fallback WAN port, which works fine for data. However, since the WR3000P supports PoE, I really want to get rid of the separate power cable and use the actual WAN port to power and feed the device cleanly.

  • What I've checked:
    • dmesg shows no signs of the 2.5G PHY being initialized properly (likely a Clause 45 / Realtek PHY / MediaTek bridge initialization issue similar to other RTL8221B / MT7981 reports).
    • Given the newer serial number (2624), it seems like a silent hardware revision update from Cudy where the device tree might need an update.

Questions:

  1. Has anyone with a newer Cudy WR3000P revision managed to get the 2.5G WAN port working?
  2. Are there any specific patches, custom DTS tweaks, or kernel flags required for these newer board revisions?
  3. Would jumping to a very recent master snapshot fix this, or is it a known pending issue?

Any advice or pointers would be greatly appreciated!
Thanks in advance.


r/openwrt • • 10h ago

bridged access point? [eli5, noob]

Thumbnail openwrt.org
1 Upvotes

I've used these instructions to configure a second router (B), to connect to a existing wifi (A).

What I want is for (B) to be isolated from (A), so that devices connected to (A) cannot see or use devices connected to (B). Almost as if (A) was the guest network, unable to use printers or NAS in network (B).

Is this a suitable way to do that? How could I test if (B) is properly isolated?