r/CommercialAV • • 21h ago

career Seattle - Looking for a job!

8 Upvotes

Hi! I live in the Seattle area and am looking for a commercial AV job.. or even just a low voltage electrical job. I have about 3,000 hours as an 06 apprentice. I have experience pulling wire, installing network, security, audio, fire, shades, etc. I've done big commercial projects, high end residential homes, and most recently I was working for EOS doing conference room AV. I have had no luck finding a job so trying reddit. Would be happy to send resume if anyone is interested..

Thanks!


r/CommercialAV • • 3h ago

design request Looking for a Reputable AV Company – Small Sound System Installation (Plains Township, PA)

4 Upvotes

We're looking for an established AV company or professional AV installer to design, recommend, quote, and install a small commercial sound system for our bagel shop in Plains Township, Pennsylvania.

We're envisioning a relatively simple setup:

- A small commercial amplifier

- 2–3 speakers strategically placed throughout the store

- Integration with our existing Mood Media player for streaming music

We're open to professional recommendations on the appropriate equipment and setup to ensure good, even sound coverage throughout the space.

We're specifically looking to work with someone who owns an established AV company or works for a reputable AV installation company, rather than an independent hobbyist.

If you're in the AV business or represent a company that handles commercial audio installations, please send me a message with:

- Your company name

- Your company website

- Your general service area

Ideally, we'd like someone who can assess the space, recommend the right equipment, provide a proposal/quote, and handle the installation.

Appreciate any recommendations or referrals. Thank you!


r/CommercialAV • • 2h ago

question Already using a 20x PTZ. What actually made your upgrade worth it?

2 Upvotes

Hello everyone! So I look after AV for a training room at our company. We use it for staff training and occasional talks, with some people joining remotely. There’s an older PTZOptics 20X-SDI Gen 2 on the presenter and a Sony ZV-E10 covering the wide. The PTZ feeds into OBS through SDI capture, and we stream at 1080p.

Before each session I check the presets for the lectern and demonstration table, test the mics, and load the slides. The setup is fairly repeatable. The presenters are less so. Someone usually ends up explaining something halfway between the two positions while I’m checking audio or bringing up their next slide.

The 20x reach already covers the room. What gets tiring is correcting the tighter shot throughout a session. We also save recordings for staff who couldn’t attend, so occasionally settling for an awkward frame follows me into the edit afterwards.

There’s budget to replace one camera, but the current one still works. Tracking and better recordings sound useful. I’m trying to work out whether either would make enough difference to justify replacing it, including getting everything set up and tested again.

Anyone upgraded a PTZ in a similar training room or lecture space? What actually made sessions easier to run, and what looked impressive in the demo but barely mattered once it was installed? Thank yall for any suggestion.


r/CommercialAV • • 7h ago

question Connector for SDI

1 Upvotes

Hello

I've an install With SDI Cable Belden 1505A.

I'll want to use the BNC connector Neutrik NBNC75BLP9  but I discovered that a special pair of pliers is needed, which costs $500.

Do you use other good BNC with a standard BNC pillers ?