r/Creality • u/Careful-Oil769 • 19h ago
Troubleshooting Chasing a Gremlin I've not encountered before
This is a part I've printed dozens of times, just re-sliced for different materials. I haven't quite figured out if it's the slicer, since there are scaling and saving "glitches" I've found (version 7.2, I think).
Three times in a row now—same part, tried a new slice—I've ended up air printing on my K2+ after a few hours. I want to blame the roll since I'm also seeing red dust shrapnel on the silver extruder wheel when it happens, so it's definitely shredding a bit, possibly due to oversized filament on this roll (Kingroon PETG bulk pack red).
However, this particular unit has 5,500 hours or so on it. The only things I've changed are nozzles, a couple of extruder covers, and lots of PTFE tubing. I also had the CFS filament detect light come and stay on for slots 3 and 4 on one unit that I couldn't clear by disassembling, air blasting, and re-assembling. Now slot 2 on my second CFS is doing the same. I said screw it on the first one and replaced the two faulty modules since they're only $25 a pop.
Replaced the nozzle, still clogged after about an hour.
Last night replaced the throat cooling fan and hot end, than a full calibration and a PID nozzle tune at 250(PETG).
I'm using BN thermokote paste on the heat break versus the included Creality stuff, been using this product for years without an issue.
Ran about 30 minutes than clogged again.
I did switch to a different roll of filament as well as replacing the tubing between the buffer and hot end. Still no luck with correcting the problem.
Tonight I'll try bypassing the CFS and running off the side spool to see if it has any effect on what's going on.
I'll also replace the whole extruder gear assembly, could be that there's something worn internally causing additional resistance.
I've never come across a problem like this that wasn't fixed by the steps I've taken so far so it's been an interesting journey so far.