r/Ford • u/ZipDango • 1h ago
Question ❔ 1962 ford econoline pick up stuck clutch.
Hello everyone!
I have a friend that has a 1962 Ford Econoline truck that was recently in a flood in his garage.
The water level was 3.5 feet deep. That was about a 5 weeks ago. Since then I have drained the fluids, there was about 3 gallons of water in the oil pan. Changed trans fluid and differential fluid.
Flushed out the oil pan as best as possible and changed the oil filter. Added fresh oil and fired it up.
The generator light was on for about 8 minutes before the brushes re-seated and the light went out.
Were going to flush the engine oil and change the oil filter again but the clutch is stuck.
I'm not sure if it's stuck on the spines or the actual plate to flywheel surface.
I was hoping before having to remove the trans if there was maybe enough room through the clutch fork hole to grab the clutch plate if I pin down the clutch pedal and pull it away from the flywheel to break the bond. Assuming that's where it's stuck at.
Any advise is much appreciated. I'm a Mopar guy myself which is why I'm here asking for input.
Thank you.