I was 22 and an "apprentice"* *at a fabrication shop, IE: I polished things.
Working on a large lathe with a 20 foot bar of 3/8" stainless, on several dead men rollers. Large die grinder with a drum sander, polishing the rod because the owner "couldn't afford" polished rod.
Also wearing the freshly made dickies work shirt, sleeves down, as instructed per management for uniforms.
Lathe was on 33~rpm. Low grit sand paper. I'm 10~' from the controls.
Drum bounces off the rod, arm hits the rod, rod grabs sleeve. It bundled at my wrist and simply ripped the shirt each rotation to my elbow. Then it started to hurt, each rotation was causing the shirt to twist and grab parts of my arm. Each mark you see was a rotation of the rod.
It was slow enough that I realized the world of trouble I was in, I think the math was something like 8-11 seconds? The rod had pulled me in and it was in my armpit, I was about to either lose my arm or start rotating with the rod. I didn't realize I'd been screaming help, and the Bridgeport operator saved my life. I'd always wondered what it would take to make me piss myself, and I learned that day.
I was warned by the owner that if I went to the Dr that there could be consequences, and being a "good employee" I never went. I tried calling out the next day, and was told to come in or I'd be fired. I spent a few weeks polishing weld color off with my good hand. At one point my entire peck and neck were black and blue. Luckily no lasting effects. The scar photo was 3~ years after. Now 15~ years later they're hardly visible. I still have the shirt, and it has the chunks of skin still in the bundle.
So in short, be careful. The machines will hurt you and keep going. They don't care. Also cherish yourself more than a shitty boss. Fuck you Adam.