r/buildingscience • • 6h ago

Smart vapor barrier for 1890s renovation

4 Upvotes

I’m trying to decide which smart vapor barrier is better for my 1890s farmhouse renovation. Foundation/ new floor system has been repaired and replaced. I’m getting closer to insulating (northern Michigan winter coming soon). Going back and forth between ProClima Intello plus vs Certainteed Membrain. Exterior of the house is original lap siding over the studs which is covered by vinyl siding ( I’m hoping when the vinyl was added there is a house wrap but I won’t be certain until I replace the windows. I’ll add the house wrap everywhere I am able if it isn’t there when the vinyl comes down for the windows.

I am leaning towards the Intello plus based on my research, only part that I am nervous about is sealing up the wall cavity too good as the house was never originally like this and there has been absolutely no rot. Current plan is to insulate with rockwool, then add smart barrier over the studs, then 1/2 inch osb to prevent further racking etc. drywall after.

Any thoughts? I haven’t reached out to either manufacturer to check thier opinions on osb going over the top and how that changes vapor permeance


r/buildingscience • • 5h ago

Question Open cell spray foam for Michigan rim joist - does this need remediation?

2 Upvotes

I had open cell spray foam sprayed into my rim joist in a 1995 era Michigan home with an unfinished basement about four years ago. When I've dug through the foam to run wires the wood behind it seems fine. But I understand that open cell in a rim joist can promote moisture issues. Do I need to remediate this, or is it probably ok to leave as is?


r/buildingscience • • 19h ago

Question Roof vents vs soffit - cold weather climate

2 Upvotes

Hi everyone

We live in a small, old house in Calgary Alberta and need to up our insulation. Soffits are not vented and would require a lot of work / $ to get them to a point that would support the extra attic insulation we also require. Roofing fella suggested we opt for several roof (intake) vents instead. It seems a popular option for new builds, but I’m also wondering what the chances of them getting blocked by snow in the winter months.

Any experience you can share? Thanks.


r/buildingscience • • 23h ago

Do any of you building science enthusiasts garden, and have a need to overwinter a few plants?

2 Upvotes

I’ve run out of time on the central coast of NJ, and I need to get my two small citrus trees into their winter home.

Not only have I lost the battle against fungus gnats in the soil the past few years, but I never really had a place inside to keep these potted plants to begin with. No basement, no sunroom, so extra space at home anywhere :(

Unfortunately, the lemon and lime pair were purchased without considering where the plants would live during the winter. Even though I was not happy to see them arrive after they were purchased, I do like them and want to keep them alive.

I need some kind of temporary solution to overwinter these plants for 1-3 cold seasons. I have access to more than enough extra,and scrap, zip sheathing, rockwool batt insulation, and everything else to build a nice little box. All the fasteners, sealant, and tape you can dream of. I can purchase anything else needed, but I wont need much. I even have a bonus bucket of Redgard, extra fiber cement and aluminum siding, and exterior paint if I want it to look nice.

What I was thinking was a mini “shed/greenhouse”. Its joists will rest on those plastic feet people build sheds on. Insulated floor(?), insulated walls. Gable, shed, or reinforced flat roof made of plexiglass, that’s also hinged for watering the plants. Extension cord for a very small space heater with great thermostat sensor and controls. Presumably it would need some kind of waterproofing on the subfloor and a small amount of intake/exhaust, accounting for outside air temp hopefully. It’s only meant to last for 1-3 years, so upmost build quality isn’t a priority. Poor ventilation won’t bother me if I can’t make it work easily enough. Would prefer to build it well, and tight enough to keep out pests, and also not have the space heater running 24/7 trying to maintain temp.

Or is there some kind of bullshit greenhouse thing I should just buy from Amazon that will be good enough to keep the warmth in? And do you know which one would work?

Don’t need to plants to produce during the winter. Minimum need is dormancy.

Interested to hear of any of you also garden and have the same problem.


r/buildingscience • • 2h ago

Best way to insulate crawlspace?

Thumbnail gallery
1 Upvotes

r/buildingscience • • 13h ago

Red Steel Building Insulation

Thumbnail reddit.com
1 Upvotes

r/buildingscience • • 16h ago

Climate Zone 5a without furring

1 Upvotes

Hello all,

I am building a home in climate zone 5a. From my research, the requirement on my plans (r-20 + 5ci) is not a great idea because of my cavity to continuous insulation ratio. I am going to use r-21 batts but am unsure of what to use on the exterior. It seems like I should be using something R-7 or higher but this would be a minimum 1.5" thick and require me to install furring strips in order to install LP Smartsiding (installs over 1" foam maximum). Can someone help me determine other options with 2x6 framing, r-21 insulation, and no furring strips? Would these options be acceptable?

Option 1: Use Zip-R9 and LP smartside attached with tetragrip nails

Option 2: Use R-21 insulation and r-5 ci but with a smart vapor retarder between drywall and studs


r/buildingscience • • 19h ago

Dense glass fire rated wall

Thumbnail reddit.com
1 Upvotes