r/Creality_k2 • • 2h ago

Question Anybody else had to replace paste between heater and meltzone?

3 Upvotes

This one is general curiosity. Im not talking about thermal grease onto the nozzle before replacing. I already did that however still having the 'Nozzle is heating unexpectedly' so I stripped the whole heater and found there is a little thermal grease between the ceramic heater and the headblock that holds the nozzle. Mine was dried up and virtually none existent.

Figured id try replacing the paste before buying a new heater and after PID tune seems to be doing alright again. Could find anywhere that suggested doing this and this is my 2nd full hot end in 800 hours.


r/Creality_k2 • • 8h ago

Troubleshooting Constant filament loading error code

Post image
2 Upvotes

Ever since the newest update I’ve been having non-stop filament loading/ unloading issues and jams.
I can’t figure out why it keeps doing this. I’ve tried doing a factory reset but it won’t let me until I resolve the error code. I have already replaced the nozzle as well as took apart the upper portion of the extruder. I do not use my external spool and exclusively use my CFS which has also given me constant issues since updating. Please help.


r/Creality_k2 • • 12h ago

Troubleshooting First layer issue

Post image
2 Upvotes

Has anyone had this issue with the first few layers bubbling up on the edge? I switched from a 4 mm nozzle to an 8 mm nozzle and they started happening, and when I switched back to my 4 mm nozzle, it kept happening. I recalibrated it. Make sure it was changed on the printer and in my slicer and nothing I change fixes it. Any ideas or helps


r/Creality_k2 • • 15h ago

Troubleshooting How to remove jammed filament from this section of extruder

Thumbnail
gallery
10 Upvotes

I have tried to heat nozzle and force it through with no success. It appears to be firmly lodged into this piece of pipe above the hot end


r/Creality_k2 • • 18h ago

Question cura & k2 printer

2 Upvotes

hey peeps

how do i set up cura to use with my k2 printer and be able to use the multi colorer cfs system ...i used the creality print software (prefer Cura ) cant get the stringing issue sorted I've look on youtube but they all seem to point to creality print when i search using creality k2

anyone help a fella out plz