I got (maybe?) a decent deal on a lightly used K2 SE recently.. I'm thinking it went cheap because the extruder motor had a broken wire, I replaced that and threw a roll of filament on and was off to the races.
The first thing I noticed is at the beginning of the print, it purges out a pretty fair amount of filament before it starts.. probably a 48'' string through the nozzle, and that before the purge line on the build plate that I'm used to from my other printing experiences. That is one of my pics - is that normal?
I'm also not sure about is this chute thing in the other pic. I'm only trying to do one color at this point, so I'm not filling a container with color change bits, but I'm not sure how this is supposed to work. Should there be something in that chute next to the rubberish nozzle wipe, or is the hole in the bottom what I should expect? I've looked high and low for documentation or demo videos and can't find anything.. the pre-print-purge tends to just go through that hole into the bottom of the printer around the plate, unless it bunches up on the side and then makes a pile that ends up sticking to the bottom of the nozzle, which goofs up leveling and then the print if I'm not sitting there watching it so I can stop it. It's weird, right?
Even with this stuff I've been able to get a few prints completed.. I started with a basic model and it did that no problem, and it even did a few larger more complicated prints that I was able to put together fairly easily with the Creality Print software. I did have some stability issues on my last couple of prints, so before I start digging in I wanted to see about these couple of issues.
Thanks in advance, K2 Friends!