r/turning • • 23h ago

I found this in a charity shop. Is anyone able to tell me anything about it?

Thumbnail
gallery
42 Upvotes

It’s light and seems really well made. I’m pretty sure it’s turned wood. Does anyone know what the markings might mean and when it could have been made. Thanks.


r/turning • • 20h ago

I mill spalted and figured turning blanks in Tennessee

Thumbnail
gallery
88 Upvotes

I use my Woodmizer to supply a group of turners and woodworkers with really nice stuff. Here’s some pictures of some recents- spalted sycamore, spalted Holly, figured maples of sorts, etc..

If you wanna tune into what I offer, feel free to join my Facebook group. This is the only place where I post

https://www.facebook.com/share/g/1Hs8nDY5fN/?mibextid=wwXIfr


r/turning • • 13h ago

Jet 1221VS Won’t run

2 Upvotes

Hi everyone. My Jet 1221 won’t run. When I try to turn it on, the drive center makes 1/4-5 revolutions and then stops. If I leave it unplugged for awhile, it seems to turn more before stopping. Sometimes it won’t turn at all. I noticed the belts squeaking the day prior and adjusted the belts, but that didn’t fix the squeak. Today when I went to turn it on as I was going to try a tiny bit of belt grease, but it simply won’t work. It’s still less than a year old so I’m a little surprised I’m having issues. Has anyone had this issue before or perhaps know what’s happening?


r/turning • • 19h ago

Dogwood handle for my new spear point scraper/gouge. Just finished it.

Thumbnail
gallery
18 Upvotes

Took some time today to use a piece of dogwood a friend gave me from his tree. It's a very good hardwood as far as strength, but wow, it doesn't like much else. Had to sharpen up the chisels to be able to work it properly, as even though they weren't dull, this stuff needs extra-sharp tools. The good part is that it's kind of hard to get it to tear out. Now I just need the epoxy I used to seat the HSS and the ring to fully set. So that'll be some time, about this time tomorrow. I left about 5 1/8 inches of HSS sticking out, so I should be good to go for a while.

I need to start getting longer pieces of HSS, though. I need to stick with 250mm at least.

Specs on this one: 7mm x 200mm, or just a hair over 1/4" and 7.8ish inches long. The completed piece is 5 1/8th inches long HSS, and the handle is 10 5/8ths inches long.


r/turning • • 22h ago

Compound stave error

Thumbnail
gallery
8 Upvotes

Obviously my set up was wrong someplace. Glued it up in halves then ran the halves thru the jointer. Corrected the angles so the 2 haves fit together. When that much wood was taken off it became oval. I am afraid if I round it up the best I can one side will end up extremley thin if there at all